12V Access in Gen2 R1S for Light Bar Installation?

Replacing my R1S Spare Tire (and Kit)

Rivian Mom · 2025-03-08T18:49:39+00:00

Last week, we got the full-size spare tire installed, including the kit. 3 days ago, I got an alert that the driver's size front tire was a little low on air. I aired it back up using the built-in compressor but it kept leaking slowly (~4psi in 12 hours). When we got it jacked up, I saw a little screw just trying to get by. A couple things to note on the process: • The instructions in the tow manual or in-truck manual are excellent and detailed. You are not too manly to read them—take the time and read them to save yourself any grief. I like that they remind you to lower the suspension before removing the spare & kit, then raise it to change it, along with a bunch of other small tips. • Don't forget to completely remove the long bolt holding the tire and jack kit down (which is also explained in the manual)—this takes only a second, and you won't have to worry about damaging the tire. It also makes removing the nearly 100lb tire much easier, as you can just pivot it upright and roll it out of the well. The hex head to remove it is molded into the threaded piece. • If you don't have the manual on you (and once jacked, you can't get back in the cab to read the onboard one), there's a QRCode on the jack and other components you can scan with your phone. This takes you directly to the tow guide PDF—this is an awesome idea, someone should get a bonus for it. • At least for the front wheel, you have to raise the jack almost all the way up to truly get the wheel off the ground. • You have to swap the center cap from the flat tire to the replacement tire. It's not a big deal, though, and can easily be done after everything else. But you probably can't remove that center cap easily while the tire is mounted. • The kit isn't half bad. It was a little hard work, but overall, nothing unbearable since I was in the garage in the shade. Here's some photos of what everything looks like. The tire is off getting patched, but should be an easy fix.

Rivian Blue

Member

Tuesday at 12:33 PM

I was planning to install a light bar on my roof rack with an spod mini6 controller in my Gen 2 R1S. I brought the car into the service center for unrelated trim issues, and was having a casual conversation with the tech about my overlanding plans and aftermarket upgrades. He mentioned that the 12V battery in the Gen 2 was no longer behind the frunk like in the Gen1, but that (as one would expect) he couldn't share any details about where I could tie into the 12V system on the Gen 2.

Has anyone successfully installed aftermarket lighting (or other accessories) that need 12V access on a Gen 2?

Any help is appreciated.

12V Access in Gen2 R1S for Light Bar Installation?

Rivian Blue

Member

Recent

Replacing my R1S Spare Tire (and Kit)

Rivian Meet-up: Compass Yellow Brightens up the Day

What’s in your Frunk? Should we start a Frunky Fridays?

Rivian R1S and EcoFlow Delta Pro Ultra: A Winning Combo for Home Backup Power

Rivian R1S Rain Sensor Issue

Rivian Mudding Saves Family: A Rivian Owners Story

R1S Subtrunk Fridge is Amazing

San Jose Rivian Experience: Rivian SC to the Rescue

Charging a Rivian R1S with a Portable Solar Battery Power Station

R1S Suspension / Hydraulics Issues

Rivian Vehicle Insurance: How Much do you Pay?

Rivian Frunk Emergency Access Tool Holder Idea

Similar threads